pre crossflow / Crossflow timing cover gasket
Ford OHV 1.0/1.1/1.3/1.5/1.6
Ford OHV 1.0/1.1/1.3/1.5/1.6
Parts
For engine with chain driven camshaft Please note, the overall dimensions of this product when packed exceeds the limit to be sent with the postal service. Therefore we have to send with our...
Copper cylinder head gasket for higher tuned 100E engine. Cut from annealed soft sheet. 152mm wide, 358mm long (overall), 1mm thick.
100E cylinder head gasket. 152mm wide, 356mm long (overall), 1.4mm thick.
head gasket for 100E Elva ohv conversion head. 154mm wide, 362mm long (overall) Cut from annealed soft copper sheet 1.5mm thick.
10hp cylinder head gasket, measures 138mm wide, 321 long, 1.4mm thick.
Head gasket for 10hp Elva over-head valve conversion head, 139mm wide, 322mm long. Copper/non asbestos substitute/copper 1.9mm thick.
bottom end gasket set for chain driven camshaft type engine Please note, when packed this gasket set is too large for post so has to be sent with our courier.
full gasket set for 8hp engine with chain driven camshaft
full gasket set for 8HP gear driven camshaft, wide block
copper cylinder head gasket for higher tuned E93A engine, cut from annealed soft sheet. 138mm wide, 321mm long, 0.90mm thick.
8hp narrow block 1932-34 - Cylinder head measures 134mm wide. Actual gasket measures 134mm wide, 321mm long, 1.5mm thick solid copper. Water jet cut from soft copper.
crankshaft rear main cap cork seal. 153mm long x 11mm wide x 6mm deep.
8hp standard block 1934-59, gasket measures 138mm wide, 321mm long, 1.4mm thick.
Prices shown include VAT @ 20% where applicable
