Water pump gasket for the E493-8501 export cast iron water pump and the AP-8501 Aquaplane aluminium water pump.
Fit between three holed base plate and body of the pump.
Fit between three holed base plate and body of the pump.
Parts
Steel water outlet pipe for mounting to cylinder head, used on early Model Y & C 1932-38.
water outlet pipe for mounting to cylinder head which retains thermostat, top radiator hose to cylinder head connection.
aluminium water connection - outlet - thermostat housing, dimensions :- base 92mm x 66mm with 73mm hole centres, overall height 60mm, accepts 38mm bore hose.
Aluminium water connection - outlet for 107E models.
Dimensions - Base 90mm x 63mm with 75mm hole centres, 52mm tall will accept a 41mm i/d hose.
Dimensions - Base 90mm x 63mm with 75mm hole centres, 52mm tall will accept a 41mm i/d hose.
Water pump. also fits later models. Quinton Hazell reference QCP181. dimension from block face to pulley 3.33 inch, pulley hud diameter 0.79 inch. application also: Ford Escort 1100 1300 & Gt...
Re-manufactured radiator cap, cast in bronze and machined, fits all unpressurized systems 1932-53.
Radiator pressure cap, 10lb pressure, 1-1/8" reach, 1198cc engine.
radiator pressure cap, 7lb pressure, 1-1/4" reach105E - 997cc engineConsul 375 Mk2 - 1701cc engine
Copper gasket for flange water pipe outlet.
fan belt - B section (tapers approx 16mm to 9mm) offered in the following lengths
fan belt - B section (tapers approx 16mm to 9mm) offered in the following lengths
900mm
900mm
fan belt - B section (tapers approx 16mm to 9mm) offered in the following lengths
fan belt - B section (tapers approx 16mm to 9mm) offered in the following lengths
fan belt - B section (tapers approx 16mm to 9mm) offered in the following lengths
Aluminium heater connection, screws into the water pump, 3/8" BSP tapered thread, outlet for 1/2" ID hose, 45mm tall (including thread)
Brass heater connection, screws into the cylinder head, 3/8bsp thread into head, outlet for 1/2" id hose, 55mm tall (including thread)
Comprising gasket, bearing and shaft assembly, slinger, seal and retainer clip.
Brass water pump impeller for the 100E water pump.
Diameter 60mm x 20mm tall, I/D 15.7mm.
Diameter 60mm x 20mm tall, I/D 15.7mm.
Water pump centre shaft and sealed bearing assembly.
Centre shaft 102.25mm long x 15.9mm diameter, bearing case 39mm long x 30mm diameter sealed at both ends.
Centre shaft 102.25mm long x 15.9mm diameter, bearing case 39mm long x 30mm diameter sealed at both ends.
Brass tube sleeve with flange.
Overall length 23mm, O/D 16.6mm, I/D 16mm, Flange diameter 22.15mm.
Overall length 23mm, O/D 16.6mm, I/D 16mm, Flange diameter 22.15mm.
Spring loaded two piece water pump seal assembly.
Overall depth 18.5mm, 36.7mm diameter with a 40mm flange, spring housing 32mm diameter.
Overall depth 18.5mm, 36.7mm diameter with a 40mm flange, spring housing 32mm diameter.
Brass 1.2mm wire retaining clip, fits into a machined groove in the water pump bearing housing.
for Y engine, new inlet water tube re-manufactured from original pattern
Prices shown include VAT @ 20% where applicable
