Long bypass oil filter/cleaner with a disposable modern cartridge which looks externally identical to the original Bedford 1042247 assembly. Canister 200mm tall x 90mm diameter with a 5mm raised...
Parts
Oil pump repair part for rebuild of 100E oil pump. Kit comprises parts drive gear on shaft 100E-6608, idle gear 18-6610, 2 piece bearing 100E-6612 and pressure spring E01A-6654
Measures approximately 70mm diameter, 108mm long, 21mm hole in the bottom.
Oil filter kit to enable the fitting of modern spin off oil filter in place of the original paper element unit. This assembly bolts on into existing holes in the engine and the spin off filter...
Board - for around engine.
Please note that this part travels flat packed and due to size must be sent via a carrier.
Please note that this part travels flat packed and due to size must be sent via a carrier.
hydraulic oil pressure warning light switch, tapered 1/8 BSP thread with lucar terminal.
suits bowl 115mm long. filter element 85mm tall, centre hole approx 21mm.
other applications for Ford:
Cortina Mk1 to Aug 1962
Cortina Mk1 1200 (113E) to Oct 1964
other applications for Ford:
Cortina Mk1 to Aug 1962
Cortina Mk1 1200 (113E) to Oct 1964
oil filter kit to enable the fitting of modern spin off oil filter in place of the original paper element unit on earlier oil pumps. this assembly bolts on into existing holes in the engine and...
rubber elbow to connect ventilator outlet tube to engine. fits other models outside our range.
suits bowl 140mm long. filter element 108mm tall, hole in centre approx 21mm, USE FF35. other applications Ford: Escort 940, 1100, 1300, GT 1968-aug 70 Escort Twin cam 1966-70 Clasic/Capri 1961-64...
Aquaplane full oil flow alloy valve chest cover , supplied with fittings and screws (without pipe).
Aquaplane alloy valve chest cover (if fitted to 100E there will be no breather)
Cast aluminium oil cooler (as original Aquaplane pattern). 285mm wide, 230mm tall, 45mm deep, female 1/4 BSP inlet/outlet thread, mounting bracket 60mm tall with 85mm long base and 8mm bolt hole....
held under head stud to hold oil cleaner pipes steady
For fitting of spin off replacement cartridge. either fit inside your own old oil cleaner, or else can be used by itself with separate mounting.
a bypass oil filter/cleaner with a disposable modern cartridge which looks externally identical to the original ZR1 assembly. supplied with one spin off filter. this filter has the following...
A complete bypass oil filter/cleaner kit with a disposable modern cartridge which looks externally identical to the original Ford assembly and which fits to the cylinder head studs. We supply all...
Braided flexi pipe with fitting. Supplied as an engine set comprising inlet and outlet
Prices shown include VAT @ 20% where applicable
